Truccioli--wood shavings

I've retreated to work some more on my Maple Branch keyblock as I'm still licking my wounds after the sizing debacle. (Although, looking over the sheets there were actually TWO usable half sheets.)
I had forgotten the obvious that while increasing the size of my drawing with the copier by 100% meant I'd have an easier time carving the details but the block surface area has quadrupled and it just takes longer to carve a large block. Especially one with lots of curvy, spiky lines.

This is a 16" x 20" block of which I'm really using just a 14 inch square ( and will cut off and use the long strip left over).

I'm working zone by zone. Outlining a leaf and stem; clearing a trench around the area with my larger U-gouge then going back in with the toh to outline all the lines before clearing the area. I'm trying to be good about clearing and cleaning up as I go so I won't have tons of cleaning to do when I'm done.

I have lost some bits and pieces of the thinner lines and I'll have to glue back in some wood to recarve a few key areas.

Carving Blood

Well, I decided to step away from my big Jajim print for a little pause. I haven't done any carving since early this year and I wanted to make some chips fly.

SO I went back into my unfinished projects file and pulled out a little print that never got farther than a preparatory sketch. While brainstorming ideas for one of the Baren Forum exchanges I posted this as one of the ideas that got nixed. Several followers--well, most of them actually since I have so few--said that it was too bad as they liked the idea.
So did I. So I went back to my preparatory sketch--it was on old mat board and I looked it over--I added some type for the title and drove over to Kinko's and made a xerox to serve as my Hanshita. Glued it down that night and spent most of yesterday carving the keyblock. This morning I recut a few spot repairs I made on some slips. It looks mostly ok but it's carved pretty shallowly so printing will tell if it's deep enough.

Now I'm back into a stretch of shifts for work until next week but hope to get in to test print and see how much cleaning up I need to do on this block. And how many other blocks I'll need.